humiSonic for fan coil

humiSonic, installed on fan coils, is the ideal solution for coupling accurate control of ambient humidity with common temperature controls (guaranteed by fan coils).

The combination and accurate management of these two fundamental features of the air assures that comfortable conditions in the home or commercial environment can be reached and maintained.

Energy Saving

Ultrasound humidification is adiabatic, requires very low power consumption compared to steam solutions (40W to atomise 0.5 kg?h of water). This important feature makes humiSonic an "Energy Saving" solution in line with modern energy saving expectations.

Easy installation and maintenance

Thanks to the compactness of its design humiSonic is easy to install in new generation fan coils and at the same time can be retrofitted on existing units!

The maintenance of humiSonic consists only in periodic replacement of the transducers (once a year) and, thanks to the ergonomic design, this does not have to be performed by trained stuff.

Hygene

This is one of the main strong points of humiSonic and is guaranteed by three important characteristics:

• washing cycles are carried out periodically (even if humiSonic is in stand-by) thus preventing accumulation of dirt inside the tank;
• the drain valve ensures the humidifier empties completely once the humidification cycle has ended, also in the event of a power failure.
• the tank (made from plastic) also features silver ions, which are able to prevent proliferation of bacteria.

Complete solution

As humiSonic is fitted with an integrated control board, no external electric control board is required. The humidifier receives the power supply from the transducer (supplied completely with cable kit) while as a control signal it can be connected to a voltage-free contact (ON/OFF), be managed by the integrated micro probe (available as an accessory) or can be controlled via serial network with Modbus or Carel communication protocol.

By installing an optional card, humiSonic can be managed with an external signal (e.g. 0 to 10 V, 4 to 20 mA...) or with other active probe models.

Supply water

humiSonic operates with demineralised water.

Whenever normal water is used, the life span of the transducer will be decreased; in particular, the more mineral salts the water contains the shorter the maintenance interval for cleaning or replacement of the transducers.